Chrysler 74mm throttle body Chrysler 74mm throttle body upgrade January 2018 the user whalesac on miata.net posted a very detailed post on using the Chrysler 74mm drive by wire throttle body as a replacement for the stock 60mm
jet stream Jet Stream ram intake install As I outlined in this post I want to optimize the intake for better flow and hopefully lower initial IAT measured at the air box. The stock setup is actually
mazda mx-5 New intake plans, Jet Stream Ram Super Intake The stock NC intake is pretty good from factory. Inlet is in the front right corner above the radiator into a muffled intake snorkel that travels across the front into
nc IAT, ECT and pressure drop mesurement with stock intake on a 1.8 NC I finally got the time to do some temperature and vacuum measurements on the stock intake system. I used OBDII readings via my Innovate OT-2 to iPhone. The mesurements was done with 24 C ambient. First snapshot was after warming up the car and
msm New charge piping. The stock MSM intake piping is is not optimal with all its bends, 1.75" piping and restrictive transitions between hardpipes and rubber hoses.I'm already using FM's silicon intake pipe on the hot side as it fits the ETD manifold turbo locataion and
msm BEGI Cool Air Box On my last Trackday I noticed that the intake temp after the air filter on my FM MSM intake was 60 c on one occasion but are consistently 20c + above ambient. Not good. I always wondered if the filter locations was such a good